Portable Evaporative Cooling Fans WayCool® 1HP - Series USER’S MANUAL
10 The WayCool® evaporative cooler is a completely self-contained, portable unit capable of delivering 40 MPH velocity of air with a temperature
11 The bottom can be supplied continuously with an ordinary garden hose by attaching the supplied hose adapter (see Figure WC-1HP.08) to the
12 A drain in the bottom allows you to drain the unit for cleaning and maintenance. A drain cap on the underside of the aluminum tray covers
13 A clear vinyl hose connects the pump to the filter. From the filter, a "T" connector supplies two lines that run along the bott
14 The cooling pads are critical for proper, efficient cooler operation. They are made of laminated cellulose (paper) fibers and arranged t
15 Figure WC-1HP.07 - Fan Blower The WayCool® WC-1HP uses a belt-driven, 1 HP electric motor to drive a centrifugal blower. The blower
16 Figure WC-1HP.08 - WayCool® Control Switch The WayCool® WC-1HP control switch is mounted on the outside of one frame leg (see cover fig
17 UNIT PLACEMENT AND OTHER CONSIDERATIONS Figure WC-1HP.09 Typical WayCool® Unit Arrangement The WayCool® unit(s) should be placed
18 Operation and Maintenance UNPACKING AND INITIAL SETUP The WayCool® WC-1HP Evaporative Cooler is shipped upright in a corrugated container.
19 9. Ensure the frame legs are straight and in alignment, and that the blower is sitting level and in proper position. Maintenance Note: If
2 INTRODUCTION…………………………………………………………………………………..………… 3 Why use evaporative coolers in your work place?…………………………………..…..………. 3 How evaporative cool
20 NORMAL STARTUP 1. Place the unit in the position where it will be run. Do not attempt to lift or move the unit once it is filled. Damage to
21 COOLING PADS NOT WETTING 1. Ensure that the bottom has water. 2. Ensure that the motor switch is in the start position and the pump switch
22 SPLATTERING Out Front See “ Line Clogs or Obstructions”. LEAKING Out Bottom Check for cracks on the bottom. If a crack is found, repair
23 The oscillator, in this WayCool® unit, is operated by a 4 RPM gear motor (WC-OSCGEARMTR) that
24 BLOWER DUCT APPEARS TO JUMP WHILE OSCILLATING 1. The blower duct may be fastened too tight against the top of the WayCool®. The nut above
25 Wiring Instructions for WC-ASOKIT 1. Turn off unit and unplug from power source. 2. Remove blower duct. 3. Remove the two #2 square h
26 17. Unscrew the yellow wire nut that is on the three white wires, and separate the white wire that goes to the pump pigtail and attach the f
27 Support information Using this equipment for any other purpose than it was intended or in a way not within the operating recommendations sp
28 THE SCHAEFER WARRANTY Schaefer Ventilation Equipment, LLC, warrants to the original purchaser that our products which prove to be defective
3 WHY USE EVAPORATIVE COOLERS IN YOUR WORKPLACE? • The WayCool® evaporative cooler requires little space, has a low initial cost, is inexpensiv
4 HOW EVAPORATIVE COOLING WORKS Figure WC-1HP.02 - Evaporative Cooling Principle Evaporative cooling is the same process your body uses to c
5 The intent of this manual is to help you in two ways: to provide you with step-by-step instructions for quick and easy assembly of your product
6 Warning and Danger Decals have been placed on the equipment to warn of potentially dangerous situations. Care should be taken to keep this infor
7 Follow Safety Instructions Carefully read all safety messages in this manual and on your equipment safety decals. Follow recommended precautions
8 READ AND SAVE THESE INSTRUCTIONS! • This is an electric device with moving components. There is the possibility of fire, electric shock, or inju
9 • Height and Width – 33” X 33” wide X 54” high (with casters and directional blower duct) • Shipping Weight - 225 pounds • Blower - Doubl
Comments to this Manuals