Schaefer WayCool User Manual download pdf (Page 11)

The bottom can be supplied continuously with an ordinary garden hose by attaching the supplied hose

adapter (see Figure WC-1HP.08) to the fill connection, or it can be filled manually.

With a continuous water supply connected, the float valve in the bottom (like the one in your toilet tank) rises

and falls with the water level. A linkage attaches the float to the shutoff valve in the fill connection. As the

water level rises to normal operating level (about 5" deep), the float valve shuts off the water supply. When

the water level drops, the float valve reopens to maintain a normal operating level.

After unplugging the unit, the bottom can also be manually filled with a hose or bucket; if a hose connection

is impractical. Simply remove any of the plastic retaining grates and one of the cooling pad sections and

place the hose, or pour the water, directly into the bottom. When you fill the bottom manually it can be filled

to a higher level, but make sure someone monitors the filling operation to avoid overfilling and flooding.

Note: Water damage due to overfilling is not covered by the warranty.

Note: When you run the unit and manually fill it, check the water level frequently so it does not run

dry. Operating the pump without water will damage it or reduce its service life. This is not covered by

the warranty. The cooling effect also stops if the pads dry.

Note: Pads and grates must be replaced before operating unit.

ATER SUPPLY SYSTEM

ctual WC-1HP

ayCool®

aries slightly from

unit shown here.

Figure WC-1HP.05 – Water Supply System

Foam

Filter

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

No comments

Schaefer WayCool User Manual Page 11