Schaefer WayCool User Manual download pdf (Page 26)

17. Unscrew the yellow wire nut that is on the three white wires, and separate the white wire

that goes to the pump pigtail and attach the female disconnect from the hardware bag to

this wire. Place this disconnect on Post 2 on the relay.

18. Twist the white wire from the power cord, the white wire from the motor cord, the wire

labeled F2 on the float switch, and the jumper labeled C from Post 7 on the relay all

together and connect all four of them with a red wire nut from the hardware bag.

19. Connect the female disconnect that is attached to the wire labeled F1 on the float switch to

Post B on the relay.

20. Re-install the cord connector into the electrical corner.

21. Place the electrical corner back into the bottom, but do not re-attach with the screws.

22. Plug the pump and motor in and test the operation of the float switch.

23. Place the two #2 square headed screws into the electrical corner.

24. Place the top back on the unit and re-insert the two #2 square headed screws.

25. Place the blower duct back on the unit and secure it down with the top knob.

OPTIONAL ACCESSORIES

Troubleshooting the WC-ASOKIT:

WC-ASOKIT not shutting off:

• Ensure wiring is done properly

• Ensure the float switch is at an acceptable depth

WC-ASOKIT shutting off too soon:

• Ensure the float switch is at an acceptable depth

• Ensure water is at least three to five inches deep

1 2 ... 21 22 23 24 25 26 27 28

No comments

Schaefer WayCool User Manual Page 26